xYour site is set for Punchout Sessions but you did not enter from a Valid Punchout, or your punchout session has timed out after 20 min. of inactivity.
Your store
will not operate correctly!
F11 Industrial Large Inspection Stamp 1/2" Diameter
F11
Industrial
Large Inspection Stamp
1/2" Diameter
SKU:
F11
| Industrial Large Inspection Stamp - Impression Size: 1/2" Diameter |
Make your mark almost anywhere with the pre-inked industrial stamps by Xstamper. Our proprietary ink formulation is fast drying, permanent and water-resistant when fully cured. The uniquely designed caps are engineered to keep ink from drying out. These stamps are ideal for marking on any slick or hard to mark surfaces.
*Average drying time for the "F-Series" stamps is around 90-120 seconds but may vary due to atmosperic conditions.
Must Use Xstamper's Industrial Refill Ink only.
Re-Inking Instructions:
1. Remove the cap and place face down.
2. Hold stamp handle firmly and pull out the die holder from the handle.
3. Place the die holder on top of the removed cap with the impression die facing down. Hold the die firmly and remove the top plug.
4. Add 5 drops of Industrial Refill Ink into the F11 opening.
Recommendations: Re-ink your stamp overnight to allow the ink to fully absorb into the stamp pad.
Works on the following Surfaces with Results: |
A.B.S (Excellent)
Acrylic Board (Excellent)
Aluminum (Excellent)
Brass (Excellent)
Cellophane (Excellent)
Ceramic (Good)
Cotton Cloth (Excellent)
General Painted Surfaces (Excellent)
Glass (Good)
Hard & Soft P.V.C. (Good)
Leather (Good)
Melamine Coated Board (Good)
Plywood (Good)
Polyester Film (Excellent)
|
Art Paper (Excellent)
Coated Paper (Good)
Construction Paper (Excellent)
Corrugated Paper (Excellent)
Hard & Regular Tracing Paper (Good)
Letter Paper (Good)
Photographic Paper (Excellent)
Polyethylene Film (Fair)
Polypropylene (Good)
Rubber (Fair)
Stainless Steel (Excellent)
Styrofoam (Good)
Synthetic Fabric (Good)
|
|
| |
©1999-2024 Connectweb Technologies, Inc.