xYour site is set for Punchout Sessions but you did not enter from a Valid Punchout, or your punchout session has timed out after 20 min. of inactivity.
Your store
will not operate correctly!
F10 Industrial Return Address Stamp 1/2" x 1-5/8"
F10
Industrial
Return Address Stamp
1/2" x 1-5/8"
SKU:
F10
| Industrial Return Address Stamp - Impression Size: 1/2" x 1-5/8" |
Make your mark almost anywhere with the pre-inked industrial stamps by Xstamper. Our proprietary ink formulation is fast drying, permanent and water-resistant when fully cured. The uniquely designed caps are engineered to keep ink from drying out. These stamps are ideal for marking on any slick or hard to mark surfaces.
*Average drying time for the "F-Series" stamps is around 90-120 seconds but may vary due to atmosperic conditions.
Must Use Xstamper's Industrial Refill Ink only.
Re-Inking Instructions:
1. Remove the holder and take off the handle.
2. Place 10 drops of Industrial Refill Ink into the openings.
Recommendations: Re-ink your stamp overnight to allow the ink to fully absorb into the stamp pad.
Works on the following Surfaces with Results: |
A.B.S (Excellent)
Acrylic Board (Excellent)
Aluminum (Excellent)
Brass (Excellent)
Cellophane (Excellent)
Ceramic (Good)
Cotton Cloth (Excellent)
General Painted Surfaces (Excellent)
Glass (Good)
Hard & Soft P.V.C. (Good)
Leather (Good)
Melamine Coated Board (Good)
Plywood (Good)
Polyester Film (Excellent)
|
Art Paper (Excellent)
Coated Paper (Good)
Construction Paper (Excellent)
Corrugated Paper (Excellent)
Hard & Regular Tracing Paper (Good)
Letter Paper (Good)
Photographic Paper (Excellent)
Polyethylene Film (Fair)
Polypropylene (Good)
Rubber (Fair)
Stainless Steel (Excellent)
Styrofoam (Good)
Synthetic Fabric (Good)
|
|
| |
©1999-2024 Connectweb Technologies, Inc.